• img1
  • img2
  • img3

+86-574-63590985

aidewo@cnaidewo.com

Product Categories

Contact Us

Zhejiang Aidewo Electronic Technology Co.,Ltd

Add: Hangzhou Bay New Zone ,Bin Hai 5 Road No 88 ,Ningbo City, Zhejiang China

Contact: Miao Yinxia

TEL: 86-574-63590985

         86-574-63591288

Phone: 86-13586568140

FAX: 86-574-63590986

E-mail:aidewo@cnaidewo.com


Home > News > Content
Coffee Dispenser Simple Fault Handling Coffee Operator Must See!

Whether you are a shop or a barista, in addition to making coffee, you also need some basic troubleshooting of the Coffee Dispenser, so that the coffee shop in the Coffee Dispenser accidental failure, quickly resolved.

1, the problem: no steam or make coffee is not hot

Approach:

The Coffee Dispenser has just started and is not completely heated. Coffee Dispenser usually boot up to about 15 minutes, during which you need to observe the pressure table of the Coffee Dispenser, usually the pressure gauge pointer between 1-1.5. The other is in a period of time you release a lot of hot water, then you should disable the hot water for 10 minutes and then use the Coffee Dispenser to heat again.

2, the problem: steam or hot water pipe in the drip

Approach:

One may be the switch knob is not Xuan tight, Xuan tight just fine; the other is the ring aging, need to inform the supplier maintenance.

3, the problem: the handle no coffee, the machine issued a noise

Approach:

In this case, it may be the water inlet or outlet switch is closed, it may be blocked inside the water filter, then you have to start checking the working conditions of the water filter, if necessary, replace the filter.

4, the problem: coffee puddle head water network blockage

Approach:

Remove the boiled head water net, clean the powder with a Coffee Dispenser to the corresponding proportion of hot water, soak and thoroughly clean the water distribution network.

5, the problem: the extraction of coffee, there is water flowing out from the handle around

Approach:

This is either a handle without locking, or is the leading seal apron aging, replace the seal on it.

6, the problem: open grinding machine does not wear beans

Approach:

This should be the coffee beans stuck the grinder blade, and this time you should turn off the camera, and then turn the coarse plate to a larger number, boot, wait until the beginning of grinding beans, shut down and then turn the tray back to the original number The


Contact Us
Zhejiang Aidewo Electronic Technology Co.,Ltd

Address: Hangzhou Bay New Zone ,Bin Hai 5 Road No 88 ,Ningbo City, Zhejiang China

Tel: +86-574-63590985

Fax:

E-mail: aidewo@cnaidewo.com

Copyright © Zhejiang Aidewo Electronic Technology Co.,Ltd. All rights reserved.
foottop